|
| |
 |
| |
| Latest News |
| |
 |
Fusion Clad Precision Technology latest news |
| |
With no less than 16 years of history in the industrial repair and rebuilding business, we are proud to announce that we have completed yet another level of confidence and excellence in Management Control of our processes. Assessed by QA International Certification, we have successfully achieved Quality, Environment, Health and Safety (QEHS) Certifications; ISO 9001:2008 Quality Management System, |
|
| |
|
 |
| |
|
|
|
| Oil & Gas |
Since 1995, Fusion Clad has been providing component rehabilitation services and prides itself as being one of the pioneers in recovering components. We enable the "Sustaining" factor in the Oil and Gas industry, ensuring durability of each drilling equipment and prolonging its operational status with our approved procedures. This is the key to our success, and we strive towards the next milestone in achieving cost savings in this sector.
For more than eight years, we have been a qualified and approved repair centre for more than four major Oil & Gas companies serving the Far East as well as the Middle East. |
| |
| |
 |
Stub welding of Collars
This collar is being Stub-welded on one end due to heavy Wear on the internal diameter.
This is an especially approved Method of repair certified by each customer for the Procedures. |
|
 |
Actual Stub Welding in progress |
|
|
 |
Internal Diameter Washout welding repair
The Internal diameter was rebuilt by our special welding process and torch, which is able to reach more than 4 feet.
Special material can be used to rebuild on material such as Inconel and other hard facing material. |
|
|
 |
Stub welding of Collars
This is a Stub welding of Down hole Mud rotors using very special proprietary procedures especially for the alignment of the Rotor lobes and the straightness of the rotors.
The salvage of rotor is achieved by combining the two good sections together to make one good length. This results in huge cost savings for the Oil and Gas industry. |
|
|
 |
Hard Facing of Non Magnetic parts
These part are Hard faced with Tungsten Carbide over the Outside diameter with three rings at designated areas for Wear protection as part of the requirement.
Such Wear Surfacing is homogeneously welded with fine & close Carbide matrix for extreme wear protection. |
|
 |
Tungsten Carbide Hardfacing or Hard Banding |
|
|
 |
|
|
| |
|
